Velleman DVR-4LCD Manuale Utente Scaricare il pdf (Pagina 6)

DVR4LCD

26/10/2009 ©Velleman nv

6. Hardware setup

Installing the Hard Disk Drive (HDD)

Refer to the illustrations on page 3 of this manual.

• Obtain a suitable HDD (not included), type SATA (Serial Advanced Technology Attachment).

• Make sure to unplug the device from the mains before servicing and do not touch any electronic

circuitry to avoid electrostatic discharge.

• Place the device with the LCD facing down on a flat steady surface. Be careful not to damage the

LCD.

• [1] Lift the plastic cover at the interconnection between the screen and the stand and release the

4 screws (see arrows). Remove the whole stand.

• [2] Remove the blank plate by releasing the two screws (see arrows).

• [3] Place DVR module as indicated and release the 3 screws (see arrows). Open the top cover by

sliding it towards the back of the module.

• [4a&b] Locate the power supply cable [A] and data bus [B] and connect them to the applicable

connectors of a hard disk drive (not included).

• [5] Insert the HDD into the DVR module and secure it with at least 2 screws (see arrows).

• Slide the top cover back on the DVR module and secure it with the 3 screws (see [3]).

• [6] Gently slide the DVR module into the monitor as indicated ([C1] must be next to [B]). Do not

force. Secure with two screws (see arrows).

Connecting the video monitor

• Connect the VGA input of the monitor [B] with the VGA output of the DVR module [C1].

Connecting a camera

• Obtain up to four suitable cameras (not included). Each camera needs its own power supply.

• Connect the video output of the camera to either video input at the back of the DVR. The number

on the cable represents the channel number. Video channel 1 = V1, Video channel 2 = V2 ...

Connector type is BNC.

DVR/PTZ not applicable

…

NUM KEYS Select channel or enter DVR password.

LCD adj. Enter LCD menu to adjust the monitors’ settings.

Note: this is also the only way to adjust the audio level.

Menu Enter (or exit) the DVR set-up menu

No functionality

display mode

Press to display video input in full screen mode. Press again to

scroll through the video inputs. Press to return to

simultaneous display of the 4 input channels.

arrow keys move through the menus and change selected settings

return enter sub-menu or confirm setting

list Display list of recorded files. Select from RECORD – MOTION –

ALARM – TIMER - FULL

play press to play-back a recorded file

rewind fast rewind the shown video

fast forward fast forward the shown video

stop stop play-back

slow play-back a recording at a slow speed

snap take a snapshot and save it to the USB device (not incl.)

pause press to pause the shown video

No functionality

audio press to select the desired audio channel

zoom Press to enlarge image. Not applicable when display mode is set

to “default”.

No functionality (PTZ controls)

1 2 3 4 5 6 7 8 9 10 11 ... 34 35

Commenti su questo manuale

Nessun commento

Velleman DVR-4LCD Manuale Utente Pagina 6

Commenti su questo manuale

Prodotti e manuali riguardandi Registratori Video Digitali (DVR) Velleman DVR-4LCD